Erreka ARES Manual Del Instalador página 23

None of the hazardous parts of the operator
are designed to be installed at more than 2.5
m above ground level or other access level.
The operator cannot be used with an actuated
part with a pedestrian door unless it is able to
make the pedestrian door work safely by itself.
Ensure that any trapping between the
actuated part and the surrounding fixed parts
due to the opening movement of the actuated
part is avoided (except for pedestrian doors
that move horizontally).
Ensure that any trapping between the
actuated part and the surrounding fixed parts
due to the movement of the actuated part is
avoided for pedestrian doors that move
horizontally. This can be achieved if the
applicable distance is less than 8 mm.
However, the following distances are
considered sufficient to avoid any trapping of
the parts of the body indicated below:
• For fingers, a distance over 25 mm
• For feet, a distance over 50 mm
• For heads, a distance over 300 mm
• For the whole body, a distance over 500
mm
Protection is required if these distances cannot
be achieved.
The details to install the operator are shown in
the "Installation" chapter of this guide. If
The product should be dismantled by qualified
personnel at the end of its working life.
This product consists of a variety of materials,
some of which can be recycled and others which
must be disposed of. Users must be aware of the
different recycling and disposal systems envisaged
in local regulations.
deformable edges or protective devices not
supplied with this device are installed, see the
instructions for these components.
The actuating member of a maintained action
switch must be placed in direct view of the
actuated part but away from moving parts.
Unless operated with a key, it must be
installed at a minimum height of 1.5 m and
inaccessible to the public.
Details on how to regulate the controls are
s h o w n i n t h e r e l e v a n t s e c t i o n o f t h e
instructions manual for the ERREKA control
panel used.
Once installed, ensure the mechanism is
regulated correctly and the protection system
and any manual release devices work properly.
Permanently affix the label for the manual
release device next to the appropriate
member.
The list of all components included in the
operator is shown in the "Unpacking" section
of this guide.
The specification of the type of door, gate,
garage door or window the operator is
intended for, the size and mass of the
actuated part or the mass of the actuated part
and required torque are shown in the section
"Operator features". The position or positions
the operator can be installed in can be seen in
the "Installation" section of this guide.
WARNINGS FOR SCRAP
S o m e p a r t s o f t h i s p r o d u c t m a y c o n t a i n
contaminating or hazardous substances which, if
released, could harm the environment and human
health.
GENERAL SAFETY INSTRUCTIONS
Discarding this device along with
household waste is forbidden. Carry
out selective sorting according to local
regulations.
ARES electro-mechanical operator
19