Installation; Connecting The Power Cord; Adjusting The Display Angle; Loading Paper Roll And Ribbon Cartridge - Sony SnapLab UP-CR10L Manual De Instrucciones

Installation

Connecting the Power Cord

Connect the supplied power cord to the ~ AC IN connector
on the back of the unit, and then connect the plug to a
power outlet.
Power cord (supplied)

Adjusting the Display Angle

The display angle can be adjusted to make the display
more easily viewable. Eight settings are available for angle
adjustment.
When storing the unit, pull the display forward until
completely upright and then push it backward until
horizontal.
10
Installation
Loading Paper Roll and Ribbon
Cartridge
Handling the paper roll and ribbon
cartridge
Notes
• The print pack contains two ribbon cartridges and two
paper rolls. Be sure to use the ribbon cartridge and paper
roll in the same carton as a set. (See "Ribbon Cartridge
and Paper" on page 55.)
• The number of sheets that can be printed depends on the
print pack type. The table below lists the image count for
one ribbon cartridge and paper roll set.
Print pack 2UPC-C13
Number of
sheets
Print size
• Do not replace the ribbon cartridge and paper roll before
they are used up. Otherwise the above number of sheets
may not be achieved.
• Place the paper roll vertically. If you place the paper roll
horizontally, the paper roll may roll around and fall. This
Power outlet
may cause an injury.
• Hold the paper roll with both hands so that you do not
drop it, because it is heavy. Dropping may result in an
injury.
2UPC-C14
300 (sheets) 200 (sheets)
3.5 × 5 inches 4 × 6 inches
(89 × 127 (102 × 152
mm) mm)
Hold the paper roll with both hands.
2UPC-C15
172 (sheets)
5 × 7 inches
(127 × 178
mm)