Ribbon Cartridge And Paper; Specifications - Sony SnapLab UP-CR10L Manual De Instrucciones

Ribbon Cartridge and
Paper
Each printing pack contains two sets of the ribbon
cartridge and paper roll combination.
Be sure to use the ribbon cartridge and the paper roll in the
carton as a set.
2UPC-C13 series Self-Laminating Color Printing
Pack
Contains color ribbon cartridge and paper.
Ribbon cartridge for printing: 2 rolls
3.5 × 5 inches print paper: 2 rolls
2UPC-C14 series Self-Laminating Color Printing
Pack
Contains color ribbon cartridge and paper.
Ribbon cartridge for printing: 2 rolls
4 × 6 inches print paper: 2 rolls
2UPC-C15 series Self-Laminating Color Printing
Pack
Contains color ribbon cartridge and paper.
Ribbon cartridge for printing: 2 rolls
5 × 7 inches print paper: 2 rolls
Printing capacity
Each printing pack contains two sets of the ribbon
cartridge and paper combination. One set of the ribbon
cartridge and paper allows you to print the following
number of sheets.
Print pack 2UPC-C13
Number of 300 (sheets)
sheets
Print size 3.5 × 5 inches
(89 × 127
mm)
Notes
• However the number of sheets that can be printed may
not be guaranteed if you replace the ribbon cartridge and
paper before the ribbon cartridge and paper run out.
• Always use a designated print pack.
2UPC-C14 2UPC-C15
200 (sheets) 172 (sheets)
4 × 6 inches 5 × 7 inches
(102 × 152 (127 × 178
mm) mm)

Specifications

Power requirements
100 to 240 V AC, 50/60 Hz
Input current 3.0 to 1.3 A max.
Operating temperature range
5 to 35°C
Operating humidity range
20 to 80%
External dimensions
Approx. 275 × 300 × 380 mm (WHD)
7
(10 /
8
(excluding the maximum projecting
parts)
Mass Approx. 11 kg (24 lb 4 oz) (printer only)
Printing system Dye sublimation thermal transfer
Thermal head 11.8 dot/mm (300 dpi)
Gradations 256 levels (8 bits) each for yellow,
magenta and cyan
Picture size 2UPC-C13: 89 × 127 mm (3.5 × 5 inches)
2UPC-C14: 102 × 152 mm (4 × 6 inches)
2UPC-C15: 127 × 178 mm (5 × 7 inches)
Printable pixels 2UPC-C13: 1,100 × 1,536 dots
2UPC-C14: 1,248 × 1,848 dots
2UPC-C15: 1,536 × 2,148 dots
(The top and bottom and right and left
portions will not be printed by about 2
mm)
Printing time 2UPC-C13: Approx. 13 sec.
2UPC-C14: Approx. 16 sec.
2UPC-C15: Approx. 17 sec.
Input connector AC IN (for power)
Control connector
RS-232C (External control interface,
D-SUB 9-pin connector) (1)
USB function port
Hi-Speed USB (USB2.0)
USB host port for the USB flash memory
Memory card slots
"Memory Stick" interface slot (1)
SD Card interface slot (1)
CompactFlash card interface slot (2)
(One of the two slots is used as expansion
slot located inside the side door.)
SmartMedia card interface slot (1)
xD-Picture Card interface slot (1)
Ribbon Cartridge and Paper / Specifications
7 15
× 11 / × 14 / inches)
8 16
55