Worx WR206E Manual De Instrucciones página 16

3.2 The battery can be replaced manually
A. Press the button on the battery cover and open the cover.
B. Take out the old battery and install the new battery pack.
C. Close the battery cover.
NOTE: Install the battery pack according to the polarity direction of the battery marked on the physical object.
4. Keep it stored over the winter
Although Landroid Vision is designed and built to survive the most severe weather conditions, we recommend storing it in your
shed or garage during the winter. To prepare it for winter hibernation:
A. Clean it thoroughly.
B. Fully charge the battery.
C. Turn the power off.
4.1 Getting back to work in the Spring
When it is time to re-start Landroid Vision for the new season, please perform the following checks:
A. Update the time and date settings via the App.
B. If you notice signs of oxidation on the charging contacts of Landroid Vision and the charging base, clean these with a fine grade
emery cloth.
C. Full charge Landroid Vision's battery before operating.
5. Keep it updated
Landroid Vision is always improving and new software versions are made available for free. Always keep Landroid Vision software
updated to make the most of your machine.
5.1 Check which software version you have
The software version number can be seen when the Landroid Vision is powerd-on.
5.2 Over-the-Air (OTA) updates
If your Landroid Vision is connected to your Wi-Fi network, you will be notified that new software is available via the App. Once you
confirm, the update will happen automatically Over-the-Air.
5.3 Manual updates
A. If your Landroid Vision is not connected to your Wi-Fi network, you can still update it to the latest software version with a USB
stick.
B. Regularly visit the Worx Landroid Vision website to check if any new version is available. If you subscribed to Landroid Vision
email list, you will be notified when a new version is available.
C. Download the latest software version at our website.
D. Take a blank USB stick formatted in FAT32.
E. Save the file and extract the content to your USB stick.
F. Make sure your Landroid Vision is getting charged.
G. Turn off Landroid Vision.
H. Open the battery cover of the Landroid Vision to access the USB port.
I. Insert the USB stick in the port.
J. Turn on Landroid Vision.
K. Without lifting Landroid Vision, remove the USB stick when "Please remove the USB key" is displayed.
L. The update will begin automatically and may take a while. Landroid Vision will restart automatically after the update is comple-
ted.
NOTE: Make sure Landroid Vision is charging or the battery capacity has reached 50% prior to starting the firmware update.
6. Remove the charging tower
A. Simultaneously press the two clips on the charging tower cover to remove the charging tower cover. (See Fig. 1)
B. Use a screwdriver against the charging tower pin, then remove the charging tower. (See Fig. 1 - Fig. 2)
NOTE: When Landroid Vision is not in use for a long time, removing and properly storing the charging tower can prolong the
service life of the charging base.
16
EN