Worx WR206E Manual De Instrucciones página 19

MESSAGE CAUSE
With the "Lock Function"
enabled, if your Landroid
Vision does not receive a
signal from your Wi-Fi router
for 3 days, then it gets locked
as a security measure.
Mower locked!
This could be because
your router lost its power
or because you changed
your Wi-Fi router or network
provider.
RFID is not installed correctly.
RFID reader error!
RFID signal is weak.
Camera covered by dirty
Camera blocked!
things.
NOTES
A. Before turning power on, always check Landroid Vision is inside its working area. If not, the message "Outside working area!
Press START to reset" will be displayed. This message is also displayed when Landroid Vision is partly but not completely inside
its working area.
B. If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging base: press
. Landroid Vision will go to its base and stay there. Please note Landroid Vision will now wait until the next scheduled mowing
session. If you want to re-start it at anytime, press
C. If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer to
the installation instructions and check your set up is correct with its help.
D. If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging base: when Landroid Vision runs out of charge, take it manually to the charging base.
E. If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then
restart it. If the problem cannot be solved, please contact our Customer Service for help.
TROUBLESHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM CAUSE
The LED light on the charging
There is no power.
pile does not turn on.
Landroid Vision turns on,
Landroid Vision is searching for
but the blade disc does
the charging base.
not spin.
The blade disc is unbalanced.
Landroid Vision vibrates.
Blades may be damaged.
ACTION
Please reconnect Landroid Vision to the Wi-Fi networtk it has been origi-
nally paired with. If this is not possible, contact Cutomer Service.
Check if RFID is correctly installed.
Install the RFID with same number beside the original one.
Clean the camera.
then to start your Landroid Vision.
SOLUTION
Check the charging base is connected properly to the charger
and the charger is connected to a suitable power supply.
This is normal: when Landroid Vision needs to recharge, the blade
disc does not rotate while it is searching for the charging base
automatically.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
EN
then
19