Worx WR206E Manual De Instrucciones página 18

MESSAGE CAUSE
WRONG PIN! Please
PIN code is wrong.
retry.
Blade disc is blocked by an
object, e.g. a branch.
Blade motor fault!
Press START to
reset.
Blade is over-loaded by thick
dense grass.
Wheels motor fault!
Wheel motor is blocked in
Press START to
some way.
reset.
This could have happened
when Landroid Vision came
Upside down! Press
into contact with a sloping
START to reset.
surface which made it over-
turn.
Mower trapped!
Press START to Landroid Vision is trapped.
reset.
Mower lifted! Press Landroid Vision has been
START to reset. lifted up.
Battery voltage too
Battery exausted, and needs
low! Please change
to be recharged.
battery.
Battery temperature Temperature is too high (more
out of range! than 45
Please wait. than 4
Can't find charge Machine doesn't have
station press START enough power to go back to
to reset. charging base.
18
ACTION
Input the correct PIN or re-set your PIN.
Turn power off.
Turn Landroid Vision upside down and check if there's anything preven-
ting the blade disc from rotating and remove any obstruction.
Turn Landroid Vision upright.
Turn power on. Press start.
Turn power off.
Take Landroid Vision to an area with short grass or adjust the cutting
height to a higher setting.
Turn power on. Press start.
Turn power off and take Landroid Vision to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
Vision upside-down and check if there's anything preventing the wheels
from rotating.
Remove any obstruction, turn Landroid Vision upright, turn power on.
Turn Landroid Vision upright and remove any obstacle that might have
caused Landroid Vision to overturn.
Turn power off.
Take Landroid Vision to an area of your lawn free of obstacles, then turn
power on. Press start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid Vision upright, turn power
on.
Turn power off.
Take Landroid Vision to an area clear of obstacles, turn power on. Press
start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down and check there's anything that can cause Landroid Vision
to be lifted up.
Remove any possible object, turn Landroid Vision upright, turn power
on.
In this case you must turn Landroid Vision off and place it in the charging
base, then 'Emergency charging' will be displayed and it will start
charging. If the battery error still persist, your battery is damaged and
need to be changed.
Place the charging base in a shady area or wait until it reaches the nor-
C) or too low (less
0
mal temperature.
C) when charging.
0
Take Landroid Vision to the charging base.
EN