Worx WR206E Manual De Instrucciones página 20

SYMPTOM
Grass is being cut
unevenly.
The secondary area is
not mowed.
The charging time is
far more than the rated
charging time.
The mower does not
charge.
Landroid Vision is starting
to have shorter run-times
between charges.
Landroid Vision is not
operating at the correct
time.
20
CAUSE
Landroid Vision does not work
enough hours per day to cut the
grass.
Mowing area is too big for the
size of Landroid Vision you have.
The blades are dull and not sharp. Change all the blades and screws in order to balance the bade disc.
The cutting height is set too low
for the length of the grass.
Grass or another object has
wrapped around the blade disc.
There is a build-up of grass in the
blade disc or motor frame box.
Recognition error
Programming error
There are obsacles between the
RFIDs in the pathway.
The boundary of the passage wi-
thin 1.5 m range of the boundary
wire for the RFID is curved.
Poor connection caused by
debris on the charging strip.
The charging protection
program is activated due to high
temperature.
There is no power.
Something is clogging in the
blade disc creating friction and
increasing power consumption.
Landroid Vision is shaking heavily
because the blade disc is unba-
lanced.
The battery may be exhausted
or old.
The working time is up.
The clock is not set to the cor-
rect time.
Programmed cutting times for
Landroid Vision are not correct.
The percentage of weekly ope-
rating time set through App has
changed.
SOLUTION
Try adding more hours to the mowing schedule.
Try decreasing the size of the mowing area or increasing working
time.
Raise the cutting height and then gradually lower.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Remove the obstacles, such as piles of leaves, weeds and wil-
dflowers.
Make sure the RFIDs are installed correcly and reprogrammed.
Remove the obstacles.
Ensure that there is no boundary curved within 1.5 m range of
the boundary wire for the RFID.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
Place the charging base in a shady area or wait until the
temperature has cooled down.
Check the power cord is connected properly to the charger and
the charger is connected to a suitable power supply.
Make sure both the charging strips on the mower touch the
center of the charging contacts on the charging pile.
Take off the blade disc and clean it. Maybe the grass is too high
and too thick.
Check the blade disc and blades, remove debris and foreign
objects from the blades and blade disc.
Replace the blades with a new set.
Replace battery.
Reset the working time.
Set the clock to the correct time.
Change the time settings for the mower to start and stop.
Set the correct percentage through App.
EN