Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Never start the measurements if you have wet or
damp hands.
Do not perform measurements in explosive atmos-
phere (e.g. in the presence of flammable gases, va-
pours, dusts, etc.). Using the meter in such condi-
tions may result in sparking and cause an explosion.
Function
A DC (
V DC, V AC, voltage frequen-
cy, duty cycle
Resistance, continuity, diode
test, capacitance, temperature
2.2 Safety symbols
This symbol located near another symbol or terminal,
indicates that the user should read the further information
contained in the manual.
This symbol located near the terminal, indicates that in
normal use there is a possibility of dangerous voltages.
Protection class II – double insulation
Terminals with this marking cannot be connected to a
circuit where the voltage to ground exceeds the maximum
safe voltage of the device.
40
The limit values of the input signal
), A AC
CMP-402 ● CMP-403 – USER MANUAL
The maximum
input value
400 A DC/AC
1000 V DC/AC RMS
300 V DC/AC RMS
Publicidad
