Tighten The Belt - Erreka DOLFIN DOS424E Manual Del Instalador

INSTALLATION
Anchor the belt
Position the belt anchoring

Tighten the belt

56
Installation Manual
1
1
2
1
2
1 Position the belt (1) in its anchoring point (2) as
shown in the figure (the belt should be taut).
P153L
1 Position the cover (1) at the end of the guide
2 Insert the anchoring (2) with the belt.
3 Carry out the same operation at the other end of the
guide.
P153M
1 Release the operator and place the gate in an
intermediate position.
2 Tighten the belt with the nut (1). Do not tighten the
belt excessively, as this will impede operation.
O
THE BELT MUST ONLY BE TIGHTENED WITH
THE ACTUATOR UNLOCKED.

For a correct finish, cut the piece of belt which
protrudes over the ties (2).
P153N