Eaton Tripp Lite Serie Manual De Instalacion Y Uso página 14

Power Cable Connection
6. Insert the L6-30P input power cable through the cable gland.
7. Connect the wires to the Normal AC source (Input) terminal blocks.
8. Insert the output cable through the cable gland.
9. Connect the wires to the output terminal blocks.
10. Tighten the cable glands.
11. Slide back and secure the SUPDMBP6K I/O cover with the four screws.
12. Connect the I/O cord set connector to the SUPDMBP6K, and secure it by tightening the two locking
screws.
Figure 4. Power Cable Connections
L1 L2
OUTPUT
2
8 Eaton Tripp Lite Series SUPDMBP6K User Guide 934705—Rev A
1
1
2
Utility
power
Load
L1 L2 L1 L2 t
INPUT OUTPUT
2
Output cable
1
To UPS output
RJ11 UPS detection
To UPS normal
AC source
L1 L2 t
INPUT
Normal AC source
cable