Eaton Tripp Lite Serie Manual De Instalacion Y Uso página 3

S S a a f f e e t t y y o o f f P P e e r r s s o o n n s s
• Installation should be performed by QUALIFIED ELECTRICAL SERVICE PERSONNEL ONLY.
• The system has its own power source when connected to the UPS (UPS battery). Consequently,
the power outlets may be energized even if the system is disconnected from the AC power
source. Dangerous voltage levels are present within the system. It should be opened exclusively
by qualified service personnel.
• The system must be properly grounded at all times. Always connect the earth wire first.
P P r r o o d d u u c c t t S S a a f f e e t t y y
• The connection instructions and operation described in the manual must be followed in the
indicated order. Disconnection and overcurrent protection devices shall be provided by
QUALIFIED ELECTRICAL SERVICE PERSONNEL for AC in/out circuits.
• CAUTION - To reduce the risk of fire, the unit should only connect to a circuit with 20 or 30
amperes maximum branch circuit overcurrent protection in accordance with the National Electric
Code ANSI/NFPA 70 and Canadian Electrical Code, Part 1, C22.1.
• Short Circuit backup protection and overcurrent protection, for the 30A Receptacles, is provided
by the building installation.
• To Avoid Risk of Fire Hazard: When hooking up the power cable connections as described in
3.3 Power Cable Connection, soft soldering of stranded wires is NOT permitted
• The upstream circuit breaker must be easily accessible.
• The unit can be disconnected from AC power source by opening the input circuit breaker, or by
shutting down the UPS (refer to the Smartonline UPS User's Manual).
• Check that the indications on the rating plate correspond to your AC powered system and to the
actual electrical consumption of all the equipment to be connected to the system.
• Never install the system in an excessively damp environment.
• Never let a foreign body penetrate inside the system.
• Never block the cooling vents of the system.
• Never expose the system to direct sunlight or source of heat.
• If the system must be stored prior to installation, storage must be in a dry place.
• The admissible storage temperature range is -15º C to +60º C.
• The operating temperature range is 0 to 40° C
S S p p e e c c i i a a l l P P r r e e c c a a u u t t i i o o n n s s
• The SUPDMBP6K is designed to work with approved Eaton Tripp Lite Series UPS systems
(contact your Eaton Tripp Lite Series reseller for more information)
• All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY.
There are NO USER-SERVICEABLE PARTS inside the UPS or Maintenance Bypass Switch.