Standard Accessories; Optional Accesories - Hitachi Koki M 12VE Instrucciones De Manejo

Ocultar thumbs Ver también para M 12VE:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
PRECAUTIONS ON USING ROUTER
1. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped fi rmly during
operation.
2. The bit is very hot immediately after operation. Avoid
bare hand contact with the bit for any reason.
SPECIFICATIONS
Model
Voltage (by areas)*
Power Input*
Collet Chuck Capacity
No-load speed
Main Body Stroke
Weight (without cord and standard
accessories)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Parallel Guide ...............................................................1
(2) Template Guide ............................................................1
(3) Wrench .........................................................................1
(4) Wing Bolt (A) ...............................................................2
(5) Lock Spring .................................................................2
Be sure to check standard accessories on product as it is
subject to change by areas.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESORIES - sold separately
(1) Template Guide
A
16.5 mm
18.5 mm
25.5 mm
28.5 mm
(2) Chuck Sleeve (8 × 6)
20 mm
6
Bottom of Sub
base
B
C
18 mm
20 mm
4.5 mm
27 mm
30 mm
M12VE
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
2000 W
12 mm or 1/2"
8000 – 22000/min
(3) Collet Chuck (8 mm)
(4) Collet Chuck (1/4")
(5) Dust collector set (Fig. 15)
(6) Fine adjustment knob (Fig. 15)
(7) Straight guide (Fig. 16)
Optional accessories are subject to change without notice.
APPLICATIONS
○ Woodworking
chamfering.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Setting the attachment angle of the handle
As Fig. 1 shows, the handle attachment angle can
be set in three stages. Use a plus head screwdriver
to loosen the machine screw attached to the handle,
adjust the handle to the desired position and retighten
the machine screw.
INSTALLING AND REMOVING BITS
WARNING
Be sure to switch power OFF and disconnect the plug
from the receptacle to avoid serious trouble.
1. Installing bits
(1) Clean and insert shank of bit into the collet chuck until
shank bottoms, then back it out approximately 2 mm.
M12SE
1700 W
22000/min
65 mm
5.3 kg
jobs
centered
on
grooving
and

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M 12se

Tabla de contenido