Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunction remedy
Malfunction
No flow of water
Water flow insufficient
Water remains cloudy
Squeaking noises on the drum drive
No display on the control system
Water is flowing via the emergency
overflow
74
Possible cause
Filter pump not switched on.
Supply to filter system or return to
pond blocked.
Bottom drain, pipe or hose blocked
Hose kinked
Excessive loss in lines
The filter fleece is not positioned cor-
rectly on the drum
Intermediate slider is open
Insufficient pump capacity
Pressure loss in the line to the pump
too high
The water is extremely soiled.
Dirt particles are not reaching the
Drum Filter Module.
Too many pond animals
Drum seal incorrectly positioned
Drum seal is damaged
Filter fleece is used up, reel is empty
Insufficient lubrication of the gear
wheels on the drum motor
Cable not connected
Control system has switched off due
to overheating (temperature switch)
Filter fleece is used up, reel is empty
Hel-X bio-elements are severely soiled
Fleece feed failed
Remedy
Switch on the filter pump, connect the
power plug.
Clean the supply and/or return.
Clean, replace if necessary.
Check hose, and replace if necessary.
Reduce line length to necessary mini-
mum.
Align the filter fleece so that the drum
grating on both sides of the drum is
covered
Close intermediate slider
Adjust the pump capacity accordingly
Adjust the pump capacity accordingly
Take the pump curve into account
Remove algae and leaves from the
pond.
If the water is particularly contami-
nated, change 30 % of the water to
avoid damage to the fish.
Optimise the water flow so that the
skimmer and/or the filter pump can
draw in the dirt particles.
Align the skimmer and/or filter
pump in relation to the water flow so
that they can draw in dirt particles.
Reduce number of pond animals
Check the seating of the drum seal
Replace the drum seal
Insert new reel of filter fleece
Grease the gear wheels with Turmsilon
Check cable connection
Protect the control system from heat
and allow it to cool down
The control system will switch back
on automatically when it has cooled
down.
Error message Er66 gives a warning
before the control system overheats
Insert new reel of filter fleece
Remove filter fleece from the drum and
turn the drum by hand to clean the
Hel-X bio-elements. If necessary, also
rinse with a water jet
Ensure correct fleece feed
If the ClearWave filter elements are
severely soiled, remove the filter ele-
ments and clean them with a water
jet
Publicidad
