Setup; Setup Protection; Control Functions - OHAUS Trooper TR3RS Manual De Instrucciones

EN-10

4. SETUP

For first time setup, step through all menus and set the parameters as desired.

4.1 Setup Protection

The Trooper Scale is equipped with menus which permit certain functions to be locked out (not changed) during
operation. If you intend to lock out changes to the setup selections you make, you will need to access the Lock Switch
located on the main PC circuit board following the setup procedure.
The Scale has five menus; CAL, SETUP, READ, PRINT and LOCSW which are entered by pressing and holding the G/N/
T/ MENU button until MENU is displayed, then releasing it. The display then switches to SETUP. To access the rest of the
menus, the PRINT/ UNITS button is repeatedly pressed until the desired menu is reached.

4.4.1 Control Functions

During setup, only the PRINT/ UNITS and G/N/T/ MENU buttons are used.
PRINT/ UNITS Button
Change between menus horizontally or change sub-menu parameters.
G/N/T/ MENU Button
Press and hold to enter menu. Enters menu and steps through sub-menus vertically.
Trooper Scale