Publicidad
Idiomas disponibles
Idiomas disponibles
EMG 1 or 2 are alternately displayed. "EMG" is also displayed at
the same time as emergency channel 1 or 2. The current channel
can be modified during the dual watch. A new key combination
disables the DW function. "DW" disappears.
M1
See the § MEMORY on page 10.
9) ANL/NB ~ HI-CUT ~ EMG ~ M2
ANL/NB
(short press)
ANL /NB: Automatic Noise Limiter / Noise Blanker . These filters allow
reducing back ground noises and some reception interferences.
Short press ANL/NB key (9) to pass the different status:
Filter icon appears on the display when status in on.
HI-CUT
(long press)
This filter cuts out the high frequency interferences.
Long press HI-CUT key (9) to enable /disable HI-CUT filter
Filter icon appears on the display when status in on.
EMG
(keys combination: • + short press)
Press one time the • key (10) and then short press the •EMG key
(9) to activate an EMERGENCY channel. "EMG" is displayed when
an emergency channel is active.
First key combination to reach then emergency channel 1, second
key combination to reach the emergency channel 2, third key
combination to return to the current channel. "EMG" disappears.
Consult the menu EMG SET on page 14.
M2
See the § MEMORY below.
10) • ~ MEMORY ~ RF GAIN ~ M3
•
(short press)
To use one of the following functions, combine using first the •
key (10) and second the key of the function: •RF PWR (6), •VOX
(7), •DW (8), •EMG (9), •RF GAIN (10), •MIC GAIN (11).
MEMORY
(long press)
This CB radio allows to memorize 3 channels with following pa-
rameters: ANL/NB (on/off), HI-CUT (on/off), AM/FM/USB or LSB.
To recall a memory:
Long press MEM key (10). If the KEY BEEP function is activated a
-
beep sounds. "MEM" blinks.
-
Short press M1 (8), M2 (9) or M3 (10) key to recall the memory."MEM"
appears on the display and the number of the selected memory
(M1, M2 or M3) blinks.
To memorize:
-
Select the channel and parameters to be memorized.
-
Long press MEM key (10). If the KEY BEEP function is activated a
beep sounds. "MEM" blinks.
-
Press M1 (8), M2 (9) or M3 (10) key during 1 second to store the
selected channel into memory. "MEM" appears on the display
and the number of the selected memory (M1, M2 or M3) blinks.
-
If the KEY BEEP function is activated a long beep confirms the
saving.
To delete a memory:
Switch off the transceiver.
-
Keep the memory key M1 (8), M2 (9) or M3 (10) pressed and switch
-
on the transceiver.
The selected memory is deleted. "MEM" and the selected memory
-
number disappears.
RF GAIN
(keys combination: • + short press)
Press one time the • key (10) and then short press the •RF GAIN
key (10). Turn the rotary knob to adjust the RF GAIN level with the
RF GAIN bargraph.
Press and hold CH knob (6) to save the RF GAIN Level.
10
Publicidad
