PRESIDENT MC KINLEY II FCC Manual Del Usuario página 16

- Weather channels
- Antenna impedance
- Power supply
- Dimensions (W x H x D)
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB
sinad
- Frequency response
- Adjacent channel selectivity : > 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection
rate
- Intermediate frequency
rejection rate
- Drain
: from 162.400 MHz to 162.550 MHz
: 50 ohms
: 13.8 V / 27.6 V
: 6.77 x 2.05 x 5.83 inches
172 x 52 x 148 mm
: 2.20 lbs / 1 kg
: Ultra light electret microphone with
support, mounting cradle, screws
: +/- 200 Hz
: 4 W AM/FM - 12 W LSB/USB
: inferior to -60 dBc
: 300 Hz to 3 KHz
: inferior to 20 µW
: 3 mV
: 3 A (max modulation @13.8V)
: 1.8 %
: 0.5 µV - 113 dBm (AM)
0.35 µV - 116 dBm (FM)
0.28 µV - 118 dBm (LSB/USB)
: 300 Hz to 3 kHz
: 2.3 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 300 mA nominal / 1000 mA maximum
F) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
- Check that the antenna is correctly connected and that the SWR
is properly adjusted.
- Check that the microphone is properly plugged in.
- Check that the RF POWER bargraph is set on maximum.
- Check that the MIC GAIN bargraph is set on maximum.
- You are using the same modulation mode than your correspond-
ent.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS
POOR
- Check that the RF GAIN bargraph is set on maximum.
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the antenna is correctly connected and that the SWR
is properly adjusted.
- You are using the same modulation mode than your correspond-
ent.
3) YOUR CB WILL NOT LIGHT UP
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
G) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your CB
Radio is ready for use (i.e. check that your antenna is connected).
Press the "push-to-talk" switch and announce your message
"Attention stations, transmission testing" which will allow you to
check the clearness and the power of your signal. Release the
switch and wait for a reply. You should receive a reply like, "Strong
and clear".
16