Publicidad
Idiomas disponibles
Idiomas disponibles
4) FINE (CLARIFIER)
The function FIN allows a fine frequency deviation during LSB/USB
reception in order to improve the clearness of your correspond-
ent's voice.
5) COARSE (CLARIFIER)
The function CRS allows a coarse frequency deviation during LSB/
USB reception.
The normal setting of both functions is on the central position.
6) CHANNEL SELECTOR ~ RF POWER ~ MENU PUSH
CHANNEL SELECTOR: CH rotary knob and UP/DN
buttons on the microphone
These switches allow increasing or decreasing a channel number.
A «Beep» sounds each time the channel changes if the KEY BEEP
function is activated (consult the menu KEY BEEP on page 13).
Message shows frequency {27 .205}.
RF POWER
While pressing the PTT switch (13), press one time the • key (10)
and press one time CH knob (6). Turn the CH rotary knob (6) to
adjust the RF POWER level with the RF PWR bargraph.
Press and hold CH knob (6) to save the RF POWER Level.
RF PWR bargraph will always be displayed in
MENU PUSH
See § MENU page 12.
7) MODE ~ PA ~ VOX ~ VOX SET
MODE
(short press)
This switch allows selecting the modulation mode AM, FM, LSB or
USB; Your modulation mode has to correspond to the one of your
correspondent.
Press MODE key (7) to select the mode:
Amplitude Modulation/ AM: communication on a field with relief
-
and obstacles at middle distance (the most used).
-
Frequency Modulation/ FM: for nearby communications on a flat
open field.
-
Upper and Lower Side Band/ USB-LSB: used for long distance
communications (according to the propagation conditions).
PA (PUBLIC ADDRESS)
Long press PA key (7) to alternate between
PA
An external loud speaker can be connected to the unit by the
PA jack plug located on the back panel PA.SP. (D).
The CB messages received or transmitted into the microphone
will be directed towards the
When PTT switch (13) is pressed, "PA" is displayed, message is {PA
LEVEL}, Meter numbers indicate signal level.
To adjust PA level, press and keep PTT switch (13), turn the CH
rotary knob (6) and use the meter numbers indicators. Message
{PA LEVEL} blinks.
If you change the
function, these functions will continue. But if you call an EMG
channel in
CB
Consult the menu PA SETTING on page 15.
TX
mode.
VOX
The VOX function allows transmitting by speaking into the original
microphone (or in the optional vox microphone) without press-
ing the PTT switch (13). The use of an optional vox microphone
connected to the rear panel of the transceiver (E) disables the
original microphone.
Press one time the • key (10) and then short press the •VOX key
(7) in order to activate the VOX function. "VOX" appears on the
display. Repeat the key combination to disable the function.
"VOX" disappears.
8
(long press)
MODE. "PA" blinks alternatively with the modulation mode.
PA
speaker and be amplified.
PA
CB
mode while using the SCAN or EMG
or
PA
mode, the
PA
mode will be cancelled and go to
mode.
(keys combination: • + short press)
CB
and
PA
mode.
Publicidad
