PRESIDENT MC KINLEY II FCC Manual Del Usuario página 11

RF GAIN bargraph always will be displayed in
M3
See the § MEMORY above.
11) WEATHER ~ ALERT ~ MIC GAIN
WEATHER
(short press)
CB functions are not allowed in
a not allowed key and KEY BEEP function is activated, the radio
sounds error tone.
Press WEATHER key (11) in order to activate the
"WX" appears on the display. A new short press on WEATHER key
(11) disables the WEATHER
The WEATHER mode allows to hear weather information. When
the mode is activated, use channel selector switches to move
through the 7 weather channels to find the active channel in your
local area.
ALERT
(long press)
The SIREN tone only sounds in
WEATHER
in mode.
Press and hold ALERT key (11) for 1 second to activate/deactivate
the ALERT function. When the function is on," "appears on the
display. If a tone is detected at the selected weather channel,
then the unit sounds SIREN tone. " " and the weather channel
number blink on the display. The unit cancel
go to WEATHER mode.
During a SIREN tone sound, press any key to stop the sound, " "
and the weather channel number stop blinking on the display.
Note: The SIREN tone sounds when ALERT is detected in the se-
lected WEATHER channel only. Use first SCAN function in
mode to detect tones in all the WEATHER channels (see the § IN
WEATHER MODE on page 9).
RX
mode.
WEATHER mode. If user presses
WEATHER
mode. "WX" disappears.
CB and PA mode. It does not sound
CB PA
or mode and
WEATHER
MIC GAIN
(keys combination: • + short press)
While pressing the PTT switch (13), press one time the • key (10)
and then short press the •MIC GAIN key (11). Turn the rotary knob
to adjust the MIC GAIN level with the MIC GAIN bargraph.
Press and hold the CH key (6) to save the MIC GAIN level.
MIC GAIN bargraph will always be displayed in
12) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and
makes the setting of the equipment into the dashboard easier.
See the cabling diagram on page 71.
mode.
13) PTT (Push To Talk)
Transmission switch, press to transmit a message,
and release to listen to an incoming communication.
TOT (Time Out Timer)
If the transmission (using the PTT (13) key or VOX) is more than 5
minutes, CHANNEL and
The time-out tone will sound until the PTT key is released.
A) DC-POWER TERMINAL (13.8 V / 27.6 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3.5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3.5 mm)
E) JACK FOR OPTIONAL VOX MIKE (Ø 2.5 mm)
C) FUNCTIONS WITH THE PTT SWITCH
1) TALKBACK
(PTT + MODE)
The TALKBACK function allows to ear your own modulation with
the CB speaker.
While pressing PTT switch (13), press the MODE key (7) to activate/
deactivate TALKBACK function. When the function is on, "TALK-
BACK" is displayed.
11
TX mode.
is displayed
start blinking, the transmission ends.