Honda XR250 Tornado Manual Del Propietário página 179

82
Brake Light Switch Adjustment
(Refer to the Safety Precautions on page 55.)
Check the operation of the brake light switch (1) at
the right side behind the engine from time to time.
Adjustment is done by turning the adjusting nut (2).
Turn the nut in the direction (A) if the switch operates
too late and in direction (B) if the switch operates
too soon.
(B)
(A)
(2)
(1) Brake light switch
(2) Adjusting nut
(1)
Bulb Replacement
(Refer to the Safety Precautions on page 55.)
C
!
aution
The light bulb becomes very hot while the light is ON,
and remains hot for a while after it is turned OFF.
Be sure to let it cool down before servicing.
Do not put finger prints on the headlight bulb, as
they may create hot spots on the bulb and cause it
to break.
Wear clean gloves while replacing the bulb.
If you touch the bulb with your bare hands, clean
it with a cloth moistened with alcohol to prevent its
early failure.
Be sure to turn the ignition switch OFF when
P
replacing the bulb.
Do not use bulbs other than those specified.
P
After installing a new bulb, check that the light
P
operates properly.
XR250 TORNADO