Nilfisk VHW200 Manual De Instrucciones página 19

CAUTION!
The following use of the device is strictly forbidden:
■ When the cable or plug is damaged. If appliance
is not working as it should, has been dropped,
damaged, left outdoors or dropped into water,
return it to an authorized service center.
■ Vacuuming liquids with machine not equipped
with specific original stopping systems.
■
Do not pull or carry by the cord, use the power
cord as a handle, do not close a door on cord, or
pull cord around sharp edges or corners. Do not
run the appliance over the cord. Keep cord away
from heated surfaces.
■
Vacuuming the following materials:
1.
Burning materials (embers, hot ashes, lit
cigarettes, etc.).
2. Naked flames.
3.
Combustible gas.
4.
Flammable liquids, aggressive fuels (gasoline,
solvents, acids, alkaline solutions, etc.).
5. Explosive dust/substances and/or ones liable
to ignite in a spontaneous way (such as
magnesium or aluminium dusts, etc.).
Note: Fraudulent use is not admitted.
Testing and guarantee
■ Testing
Each machine is subjected to a final test involving its
operation and performances. This guarantees maximum
efficiency during the work the machine must carry out.
■ Warranty
The guarantee clauses are specified in the sales contract.
How to request assistance
In the event of faults or malfunctions requiring the intervention
of specialized technicians, contact the Manufacturer or your
nearest After-Sales Service Centre.
Exclusion of liability
The machine was delivered to the user according to the
conditions valid at the time of purchase.
For no reason what so ever shall the user be authorized to
tamper with the machine.
Contact your nearest After-Sales Service Centre in the event
of faults.
All attempts by the user or by unauthorized personnel to
demount, modify or, more generally, tamper with any part of the
machine shall void the guarantee and relieve the manufacturer
of all responsibility for damage to either persons or property
caused by such action.
VHW200 - VHW201 - VHW210 - VHW211
The manufacturer shall also be relieved of liability in the
following cases:
■ Wrong installation.
■ Improper use of the machine by inadequately trained
personnel.
■ Utilization contrary to the provisions in force in the country
of use.
■ Incorrect or insufficient maintenance.
■ Use of non-genuine spares or use of spares that are not
specifically made for the model in question.
■ Total or partial failure to comply with the instructions.
■ Failure to forward the warranty certificate.
■ Exceptional environmental events
Versions and variations
CAUTION!
Some models can be supplied without a power cable
and without circuit breaker protection.
The user must provide a connection to the electrical
mains, according to the law in force, including a circuit
breaker protection appropriate to comply with the data
plate on the motor. This procedure must be performed
by qualified personnel.
CAUTION!
The vacuum cleaner is safe only if there is a circuit
breaker protection interposed in the power supply
connection, otherwise there is a risk of electric shock
and / or fire in case of overheating or short circuit.
ATEX variants (Z22)
Refer to the manufacturer's sales network for these
versions.
For ATEX devices see the instructions for "ATEX" use.
The manufacturer produces machines suitable to be used
in potentially explosive atmospheres. These variants are
manufactured according to directives and standards in force.
The relevant additional instructions are supplied together with
the machine.
HEPA variations (AU)
This machine can be equipped with a filter (HEPA). The
procedures for servicing and emptying the machine including
removing the dust container, must only be performed by
authorized personnel wearing protective clothing. Do not use
without the complete filter system in place.
Variants with circuit breaker (T)
This machine is supplied with circuit breaker protection and
with a power supply cable without power supply plug.
CAUTION!
If the connection require a socket, this must be suitably
rated according to the rated current value shown on
the vacuum cleaner data plate. This procedure must be
performed by qualified personnel.
3
[ NOTE ]
GB
F
D
E
C411