Nilfisk VHW200 Manual De Instrucciones página 20

VHW200 - VHW201 - VHW210 - VHW211
General recommendations
If an emergency situation occurs:
■ for example, accident - fault - filter breakage - fire
- etc.
Disconnect the machine from the power supply and ask
for assistance from qualified personnel.
In case the user comes into contact with the vacuumed
product, check the cautions shown on the safety
technical sheet of the product, which must be made
available from the employer.
Check the place of work and substances tolerated for the
machine suitable for liquids.
The machines must not be used or stored outdoors, or
in damp places.
Only versions with the level sensor can be used for
liquids, if not, they can only be used to vacuum dry
materials.
Version for liquids.
If foam or liquid leaks out of the machine, turn it off
immediately and contact qualified personnel for
assistance.
These devices must not be used in corrosive environment.
Residual Risks
After carefully considering the risks that are present in all
machine operating phases, necessary measures were adopted
in order to eliminate the risks for the operators, as far as
possible, and/or limit or reduce the risks deriving from hazards
GB
that cannot be completely eliminated at the source.
During operations
exposed to certain residual risks which, due to the nature of
F
the operations themselves, cannot be completely eliminated.
Therefore the installer is responsible for providing additional
information and/or hazard signals based on the location of
D
machine installation and the material that is handled.
E
Risks due to electrical hazards during maintenance
Risk of electrocution if accessing the electrical
equipment during
deactivated the electrical power supply.
It is forbidden to work on the electric equipment
before disconnecting the machine or its parts from the
electrical line.
C411
CAUTION!
[ NOTE ]
CAUTION!
CAUTION!
[ NOTE ]
and/or maintenance, operators
DANGER
maintenance without
FORBIDDEN
Have the electrical maintenance operations performed
by qualified personnel. Perform the checks on the
electric equipment as specified in the manual.
Risks to the presence of residual high temperature after
stopping the vacuum unit.
During maintenance and cleaning operations, the operator
may come into contact while the machine is stopped, with
parts of the vacuum unit with surfaces at high temperatures.
Specific warning signs placed in strategic points indicate the
hazard due to the presence of hot surfaces and the obligation
for the user to wear personal protective equipment, in particular
protective gloves.
The potentially hot parts (high temperatures) are identified as
follows:
EC Declaration of conformity
Every machine comes with a EC Declaration of conformity. See
fac-simile in fig. 12.
The Declaration of conformity is an important document
and should be kept in a safe place to be presented to the
Authorities on request.
are
having
4
MANDATORY
IT IS MANDATORY TO WEAR
GLOVES
CAUTION
DANGEROUS
TEMPERATURES
[ NOTE ]