Publicidad
Idiomas disponibles
Idiomas disponibles
VHW200 - VHW201 - VHW210 - VHW211
Before performing these operations, clean the filter
as described in the "Maintenance, cleaning and
decontamination" paragraph.
Take care not to raise dust during this operation. Wear
a P3 mask and other protective clothing plus protective
gloves (PPE) suited to the hazardous nature of the dust
collected, refer to the laws in force.
Reassemble with care to avoid trapping your hands
between the vacuum unit and the container. Use gloves
that provide protection against mechanical risks (EN
388) with a level of protection CAT. II.
Primary filter replacement
■
Remove the vacuum hose (1).
■
Use the knobs (2) to remove the cover (3) together with
the primary filter.
■
Remove the old filter from the cage and filter ring (4).
■
Install the new filter.
■
Install the cover and the primary filter in the reverse order
of removal.
■
Dispose of the old filter according to the laws in force.
Upstream absolute filter replacement
■
Use the lever (2) to release the cap (1) then pull it up and
out of the vacuum cleaner.
■
Unscrew the ring nut (4).
■
Pull out fastening disc (5) and absolute filter (6).
■
Place absolute filter (6) in a plastic bag, close the bag
hermetically and dispose of the filter in accordance with
the laws in force.
■
Insert a new filter (6) with the same filtering characteristics
as the removed one.
■
Lock the absolute filter with disc (5) and tighten the ring
nut (4).
GB
■
Insert the cap (1) again.
■
Fasten the cap with the lever (2).
F
Downstream absolute filter replacement
D
■
Unscrew the knob (1), and remove the cover (2).
■
Remove the absolute filter (3) and place it in a plastic
E
bag, close the bag hermetically and dispose of the filter in
accordance to the laws in force.
■
Insert a new absolute filter (3) with the same filtering
characteristics as the removed one.
■
Reinstall the cover (2) by fastening it with the knob (1).
C411
CAUTION!
CAUTION!
CAUTION!
Figure 7
Figure 8
Figure 9
Motor cooling fan inspection and cleaning
Periodically clean the motor cooling fan to prevent the motor
from overheating, especially if the device is used in a dusty
place.
Tightness inspection
Hoses check
Make sure that connecting hoses (1) are in a good condition
and correctly fixed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the baffle plate inside the
filtering chamber.
To clean, scrape the inlet from the outside to remove deposits.
Disposal
The crossed-out wheeled bin symbol on the
equipment indicates that used electrical and
electronic equipment must be collected and
disposed of separately from household waste. The
correct disposal of the equipment will help prevent
potential
negative
environment and human health.
Electrical and electronic household equipment must be
disposed of at the separate collection points in the residence
area. Please note that commercial electrical and electronic
equipment should be disposed of separately from the municipal
waste stream. We will be pleased to inform you about suitable
disposal options.
Wiring diagrams
12
Figure 10
consequences
for
Figure 11
the
Publicidad
