Publicidad
Idiomas disponibles
Idiomas disponibles
22
INSTALLATION
INSTRUCTIONS
Connecfing
elecfric
dryers
(conf.)
USA
only
AWARNING
. Connect the power cord to the terminal
block. Each colored
wire should be connected
to same color screw. Wire color
indicated
on manual
is connected
to the same color screw
in block. Failure to follow
these instructions
may result in a
short or overload.
. Grounding through the neutral conductor is prohibited
for: (1) new branch-circuit installations, (2) mobUe homes,
(3) recreational vehicles, and (4) areas where local codes
prohibit grounding through the neutral conductor.
Four-Wire
Connection
for Electric
Dryers:
Direct
Wire
. A 4-wire connection
is required for all mobile and manufactured
home installations,
as well as all new construction
after January 1,
1996.
. A UL-listed
strain relief is required.
1. Remove 5 inches (12.7 cm) of the outer covering from the wire.
Remove 5 inches of insulation
from the ground wire. Cut off
approximately
11/2inches (3.8 cm) from the other three wires
and strip 1 inch (2.5 cm) insulation
from each wire. Bend the
ends of the three shorter wires into a hook shape.
. Use UL-listed
4=wire #10 AWG-minimum
copper
conductor
cable.
. Allow at least 5 ft. (1.5 m) length to allow for removal and
reinstallation
of the dryer.
3. Transfer the dryer's ground wire from behind the green ground
screw to the center screw of the terminal
block. Attach the two
hot leads of the power cable to the outer terminal
block screws.
Attach the white neutral
wire to the center terminal
block
screw. Attach the power cable ground wire to the green ground
screw. TIGHTEN ALL SCREWS SECURELY. Reinstall the terminal
block access cover.
Hot
Neutral
Sf-_q_(Blac=.k)
--- (White)_
(HOd)
Ground Wi_
1" (2.5 cm)
I-q
__
Ground Wire
(1 2.57'cm)_
2. Remove the terminal
block access cover on the upper back of
the dryer. Install a UL-listed
strain relief into the power cord
through-hole;
then thread the power cable prepared
in Step 1
through
the strain reliefl
_1__...._---
Terminal
__
Block
__-_
_11111
UL-Listed
__111//
Strain Relief
4-Wire Power
Cord
Publicidad
