Publicidad
Idiomas disponibles
Idiomas disponibles
26
INSTALLATION
INSTRUCTIONS
Installation
test
(Exhaust
check)
Once you have completed
the installation
of the dryer, use this
test to make sure the condition
of the exhaust system is adequate
for proper operation
of the dryer. This test should be performed
to alert you to any serious problems
in the exhaust
system of your
home.
, Your dryer features FLOW SENSE
TM,
an innovative
sensing system
that automatically
detects blockages
and restrictions
in dryer
ductwork.
Keeping ductwork
clean of lint buildup
and free of
restrictions
allows clothes to dry faster and reduces energy
use.
- @ NOTE
The dryer should
be cool before starting this test. If the dryer was
warmed
up during
installation,
run the AIR DRY cycle for a few
minutes
to reduce the interior
temperature.
To activate
the Installation
test:
1. Press and hold the TEMR and SIGNAL buttons
at the same
time. While holding
these buttons,
press POWER ON/OFF
4. Check the display
for results.
During the two minute
test cycle, monitor
the FLOW SENSE
display on the control
panel. If FLOW SENSE is displayed,
when
the cycle ends, the exhaust
system is adequate.
If the exhaust
system is severely restricted,
the display will show FLOW
SENSE. Other problems
may also be shown with error codes.
Refer to the next page for error code details and solutions.
/
m i
I \
Lighting
: Restricted
FLOW SENSE indicates
that the exhaust
system is severely
restricted.
Have the system checked
immediately,
as performance
will be poor.
5. END of Cycle.
At the end of the test cycle, \
will display. The test cycle
will end and the dryer will shut off automatically
after a short
delay.
2. The dryer will show InS in the number
display to indicate
that
it is in duct condition
testing
mode.
3. Press the START/PAUSE button.
The dryer will run for approximately
2 minutes
to test for
blockages
or restrictions
to air flow in the ductwork.
Publicidad
