LG DLE4801W Manual Del Propietário página 27

INSTALLATION INSTRUCTIONS
27
Insfallafion fesf (Exhausf check) (conf.)
, Check the Error Code before you call for service
Err0r code
tE
HS
PS, PFor nP
Temperature sensor failure . Turn off the dryer and call for
service.
Humidity Sensor failure. . Turn off the dryer and call for
service.
Electric dryer power cord is not
connected correctly, or house power
supply is incorrect.
House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
Check the power supply or the
connection of power cord to the
terminal block. Refer to the Connecting
Electric Dryers section of this manual
for complete instructions.
Reset circuit breaker or replace fuse.
Do not increase the fuse capacity.
If the problem is a circuit overload,
have it corrected by a qualified
electrician.
• Check the duct condition
If the test displays FLOW SENSE, check the exhaust system for
restrictions and damage. Repair or replace the exhaust system as
needed.
@ NOTE
When the dryer is first installed, this test should be performed to
alert you to any existing problems with the exhaust duct in your
home. However, since the test performed during normal
operation provides more accurate information on the condition
of the exhaust duct than does the installation test, FLOW SENSE
displayed during the two tests may not be the same.
Do not interrupt the test cycle, as this could result in the wrong
results.
Even if FLOW SENSE is not displayed during the test cycle, some
restrictions may still be present in the exhaust system. Refer to
the Venting the Dryer section of this manual for complete exhaust
system and venting requirements.
J
Restricted or Blocked Airflow
/ I I
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Too many elbows or
exhaust too long
Check for blockages and lint buildup.
Make sure the ductwork Js not crushed or restrJcted.
Crushed or
damaged
exhaust