MTD 752Z165-SUB Manual Del Operador página 14

i
ii i_,i
k.
Figure 6-1
,J
12. Fill with the recommended Oil, Fig. 6-3.
(
7. Tip engine to position the oil flow, so it will drain from the
lowest point on the engine.
8. Drain the oil into an approved recyclable oil container.
NOTE: Please dispose of used motor oil in a ma nner that is
compatible with the environment. We suggest you take it in a
sealed container to your local service station for reclamation.
Do not throw it in the trash or pour it on the ground.
9. Install the oil drain plug and tighten securely.
10. Clean area around the oil drain plug.
11. Remove the oil fill cap dipstick.
Figure 6-2
WARNING! Used motor oil may cause skin cancer if
repeatedly left in contact with the skin for
prolonged periods. Although this is unlikely unless 16.
you handle used oil on a daily basis, it is still
advisable to thoroughly wash your hands with soap 17.
and water as soon as possible after handling used
oil.
18.
I
_30
40 mm_.
20w40,_Ow50 ____
15w40, 0_ _ _ _ m_lbl,,.
I
lOw40___lmJbb
I
10w30____
(°C)-30° -20° -10° 0° 10 ° 200 300 400
(°F)-20° 0° 200 400 600 800 100 °
Fig. 6-3
NOTE: DO NOT overfill oil filler. Doing so may result in oil
carry-over to the equipment and cause malfunction or
damage.
NOTE: DO NOT allow oil level to fall below and "L" mark on
dipstick. Doing so may result in equipment malfunction or
damage.
13. Wipe away any spilled oil.
14. Check the oil level by installing the Oil Fill Cap/Dipstick.
For threaded Oil Fill Cap/Dipstick models, rest
the cap on the threads, do not tighten down the
cap to check the oil level.
For quarter-turn Oil Fill Cap/Dipstick models,
tighten down the cap to check the oil level.
NOTE:See the Set-Up section earlier in this manual for
detailed instructions on identifying and checking the oil on
each of these specific engine models.
15. Remove the oil filler cap/dipstick. If the level is low, slowly
add oil until oil level registers between high (H) and low (L),
Fig. 3-2 and 3-3 in the Set-Up section.
Repeat Steps 14 & 15 to be sure that the correct oil level has
been achieved.
Once the proper oil level has been confirmed, install the Oil
Fill Cap/Dipstick. Tighten securely
Carefully disconnect spark plug wire from grounding post,
if present.
19. Carefully reconnect the spark plug wire to the spark plug.
NOTE: It is advisable to recheck the oil level after you have
operated the engine for a short while, and the normal engine
operating temperature has been achieved.
_ ARNING!
If the engine has been running, the
muffler, engine head and spark plug will be very hot.
Be careful not to touch any of these components
until they have cooled.
SECTION 6-- MAINTENANCE