Kohler K-24019-GHW-0 Instrucciones De Instalación página 4

NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support of the bath. To
avoid damage to the bath, lift at the sides of the bath.
NOTICE: Before installing a rim-mount bath faucet, refer to the Specification Sheet on the bath product page at
kohler.com for faucet area dimensions for your model.
NOTICE: Provide adequate backer board support for a rim-mount faucet; large faucets that may be inadvertently used as
a means of support are not safe for this installation.
NOTICE: To ensure a successful installation, install the bath on a level, finished floor.
Follow all local plumbing, building, and electrical codes.
To simplify future maintenance, verify that all plumbing and control board connections around the bath are easily
accessible.
Two people should perform this installation.
Use conduit to route electrical power wires from the circuit breaker.
Carefully plan moving the bath into the installation area. This bath will not easily fit through doorways.
Unpack and inspect the bath and components for damage. Return the bath and components to the carton until
installation.
This bath is designed for freestanding installation only.
If installing a rim-mount faucet, verify that there is no interference above or below the rim before drilling any holes.
Illustrations shown may not look like your actual product but they still apply to this installation.
1512795-2-A
4 Kohler Co.