Publicidad
Idiomas disponibles
Idiomas disponibles
3. Prepare the Bath
Dry fit
the drain.
NOTICE: Refer to the drain instructions to dry fit the drain to the bath. Do not cement and complete the drain
installation until instructed.
Dry fit the drain assembly to the bath. Refer to the drain instructions. Do not apply sealant or cement to the drain
components at this time.
Loosen the drain and overflow connections from the bath, and remove the drain assembly from the bath.
Dry fit the drain assembly to the drain pipe, which has already been cut to the correct height.
Temporarily position the shroud in place over the drain assembly.
With help, temporarily lift the bath into place in the shroud. Verify that the bath rim is completely seated over the
shroud to engage the alignment guides.
Verify that the drain and overflow connections line up properly with the drain and overflow holes on the bath.
Measure and record any adjustments needed to the drain or overflow tube lengths.
Remove the bath and shroud, leaving the drain and overflow assembly attached to the drain pipe.
Adjust the length of the drain tubes as needed to so that drain alignment with the drain and overflow holes in the bath.
Repeat these drain fit steps until the drain and overflow connections line up with the drain and overflow holes in the
bath.
Cement and assemble the drain and overflow components. Connect the drain tee to the drain pipe.
Apply 100% silicone sealant to both sides of the drain and overflow gaskets.
Apply slow-drying construction adhesive to the bottom of the shroud.
Carefully position the shroud over the drain, aligning the hole with the traced mark on the floor.
Optional: For extra stability, secure the shroud to the floor using four screws (not provided).
Kohler Co.
Drain Pipe
7
Apply construction
adhesive before
final positioning.
1512795-2-A
Publicidad
