Kohler K-24019-GHW-0 Instrucciones De Instalación página 11

7. Connect the Bubble Heater
1/2 NPT Tee Connections
NOTE: The water supply setup may differ depending on the type of bath faucet that is installed.
Install the tee (not supplied) to the hot water valve on the bath faucet.
Thread the supply hose (not supplied) onto the 1/2 NPT port of the tee.
Thread the opposite side of the supply hose into the 1/2 NPT brass nipple. Do not kink the hoses.
Verify that the bubble heater cord is plugged into the electrical outlet below the floor or in the shroud.
8. Complete the Installation
Carefully remove the temporary blocks and verify that the bath rim engages the top of the shroud on all sides.
Verify that all alignment guides are inside the shroud. There should be no gap between the bath and the shroud.
Install the drain flange and overflow cover according to the drain instructions.
Close the bath drain. Fill the bath to the overflow, and check for leaks.
If desired, apply a thin, continuous bead of clear or color-matched 100% silicone sealant to the seam between the
shroud and the finished floor.
Test Run the Bath
Check all electrical connections and verify that the electrical power to the bath is on.
Kohler Co.
To Bath Faucet
Hot Water Supply
Supply Hose
11
1512795-2-A