Kohler K-24019-GHW-0 Instrucciones De Instalación página 3

If the blower supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
Product Notices
IMPORTANT! The recommended operating pressure for this system is 35-60 psi (241-414 kPA).
NOTICE: Keep the area around the blower clean and free of debris. Verify that the area around the blower is free of
sawdust, insulation, dirt, and other small loose debris. Such material can block the blower air ducts and reduce the air
flow through the blower.
NOTICE: This product contains an automatic water purge mode that turns the blower on for 5 minutes after the unit is
turned off and drained.
Tools and Materials
Masking Tape 1/2 NPT Brass
1/2" 100% Silicone Sealant Construction Adhesive
Plus:
• Drop Cloth
• Shims
• 2x4s
• Wood Blocks
• 1/2" (13 mm) Exterior Grade Plywood (for Rim-mount Faucet)
Before You Begin
NOTICE: This product requires remote blower installation. Refer to the instructions included with the remote blower
kit before proceeding.
NOTICE: Adequate floor support must be provided. Note the model number on the components end of the bath, then
visit the product page at kohler.com for additional information.
1512795-2-A
Kohler Co. 3