Descargar Imprimir esta página

Kohler K-24019-GHW-0 Instrucciones De Instalación página 2

Banera autosoportada de aeromasaje caliente con superficie de calefacción

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank You for Choosing KOHLER
Need help? Contact our Customer Care Center.
• USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537
• Service parts:
kohler.com/serviceparts
• Care and cleaning:
kohler.com/clean
• Patents:
kohlercompany.com/patents
Installation Instructions
WARNING: When using electrical products, basic precautions should always be followed, including the
following:
DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault Circuit-Interrupter
(GFCI)*.
Install to permit access for servicing.
A pressure wire connector marked "Earth/Ground" is provided within the wiring compartment. To reduce the risk of
electric shock, connect this connector to the grounding terminal of your electric service or supply panel with copper wire
equivalent in size to the circuit conductor supplying this equipment.
A pressure wire connector is provided on the exterior of the pump or control within this unit to permit connection of a
bonding conductor between this unit and all the other exposed metal in the vicinity, as needed to comply with local
requirements.
NOTICE: Grounding is required. The unit should be installed and grounded by a qualified service representative.
WARNING: Risk of injury or property damage. Read all instructions thoroughly before beginning installation.
WARNING: Risk of electric shock. A qualified electrician should make all electrical connections.
WARNING: Risk of electric shock. Disconnect the power before installation or servicing.
NOTICE: Follow all plumbing, building, and electrical codes. In Canada, install this unit in accordance with the
Canadian Electrical Code, Part 1.
*Outside North America, this may be known as a Residual Current Device (RCD).
Product Information
Electrical Requirements
The installation must have two Class A Ground-Fault Circuit-Interrupters (GFCI). The GFCI protects against line-to-
ground shock hazard. Use a 120 V, 15 A, 60 Hz dedicated service for the blower. Use a separate 120 V, 15 A, 60 Hz
dedicated service for the bubble heater and heated surface.
1512795-2-A
2
Kohler Co.

Publicidad

loading

Este manual también es adecuado para:

K-24008-ghw-0K-1966-ghw-0K-1967-ghw-0K-24018-ghw-0