Toro TimeCutter MX3400T Manual Del Propietário página 35

2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position. Allow the engine to cool.
3. Clean the area around the base of the plug to
keep dirt and debris out of the engine.
4. Remove the spark plug
Checking the Spark Plug
Important:
Do not clean the spark plug(s).
Always replace the spark plug(s) when it has a
black coating, worn electrodes, an oily film, or
cracks.
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means the air cleaner is dirty.
Set the gap to 0.75 mm (0.03 inch).
(Figure 38).
Figure 38
Figure 39
Installing the Spark Plug
g027478
Cleaning the Cooling System
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the air filter from the engine.
4. Remove the engine shroud.
5. To prevent debris entering the air intake, install
the air filter to the filter base.
6. Clean debris and grass from the parts.
7. Remove the air filter and install the engine
g206628
shroud.
8. Install the air filter.
33
Figure 40
g027480
ARK