Toro TimeCutter MX3400T Manual Del Propietário página 37

Servicing the Engine Oil
Engine-Oil Specifications
Oil Type: Detergent oil (including synthetic) of API
service SJ or higher
Crankcase Capacity: 1.9 L (64 fl oz) with oil filter
Viscosity: See the table below.
Figure 43
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
Important:
If you overfill or underfill the engine
crankcase with oil and run the engine, you may
damage the engine.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Note:
Ensure that the engine is cool so that the
oil has had time to drain into the sump.
3. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it
g017552
ARK
(Figure 44).
35
Figure 44
Changing the Engine Oil and Oil Filter
Service Interval: Every 100 hours or yearly,
whichever comes first—For Kohler
engines—change the engine oil and
oil filter (more often in dirty or dusty
conditions).
1. Park the machine on a level surface to ensure
that the oil drains completely.
2. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Drain the oil from the engine
g365791
ARK
(Figure 45).