Descargar Imprimir esta página

Power Stroke PS906025P Serie Manual Del Operador página 21

Generador 6 000 watts
Ocultar thumbs Ver también para PS906025P Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING FUEL FILTER:
See Figure 22.
Occasionally the fuel filter may become clogged and need
to be replaced. To purchase a replacement fuel filter, contact
customer service or a qualified service center.
NOTE: Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
To replace:
 Turn the fuel valve to the OFF position.
 Push the fuel valve knob through the generator housing
and pull down slightly to gain access to the filter.
 Remove the fuel line from both sides of the filter by
squeezing the ends of the retaining clip with pliers.
STORAGE
When preparing the generator for storage, allow the unit to cool completely then follow the guidelines below.
STORAGE TIME
Less than 2 months  Drain gasoline from tank and dispose of in a suitable container according to state and local
2 months to 1 year
 Drain fuel from carburetor.
 Drain gasoline from tank and dispose of in a suitable container according to state and local
1 year or more
 Drain fuel from the carburetor.
 Remove spark plug.
 Drain gasoline from tank and dispose of in a suitable container according to state and local
 Put a tablespoon of engine lubricant into the spark plug cylinder. Turn the engine slowly with the
 Reinstall spark plug.
 Change engine lubricant.
After removal from storage:
 Fill with fresh gasoline.
NOTE: If storing gasoline in suitable container for later use, make sure gasoline has been treated with fuel stabilizer
according to stabilizer manufacturer's instructions.
MAINTENANCE
ordinances.
ordinances.
ordinances.
pull rope to distribute the lubricant.
 Slide the fuel line off.
 Replace with new fuel filter.
 Reinstall fuel lines to new fuel filter.
 Reinstall fuel valve knob in generator housing. Push for-
ward until knob snaps securely into position.
 Turn the fuel valve to the ON position.
TRANSPORTING
 Turn off the generator.
 Verify the fuel valve is in the OFF position.
 Make sure engine and exhaust of unit is cool.
 Empty the fuel tank.
 Do not drop or strike unit or place under heavy objects.
PRIOR TO STORING
Page 17 — English

Publicidad

loading