Publicidad
Idiomas disponibles
Idiomas disponibles
Manual Release
Emergency Disconnect System Model TDC
TO DISCONNECT DOOR FROM OPERATOR
The door should be in the fully closed position if possible.
1.
Pull emergency release handle straight down. Emergency disconnect
will open.
TO RECONNECT DOOR ARM TO TROLLEY
2.
Lift free end of door arm to trolley. Pull emergency release handle to
allow arm to engage roll pin. Release handle. Emergency disconnect
will close.
1
2
Emergency Disconnect System Model JHDC
These operators have provisions for manually operating the door in case of emergency or power failure. These
operators are equipped with a manual hoist. An electrical interlock will disable the electrical controls when the hoist is
used.
This operator includes Engage rope (green) and a
disengage rope (red) with manual hoist to electrically
disable the operator controls.
1.
To disengage, pull the disconnect rope (red).
2.
Operate the door in the desired direction
by pulling on one side or the other of the
continuous loop hoist chain.
3.
Pull the engage rope (green) to operate the door
again electrically.
OPERATE A MANUAL HOIST
1.
Pull down on the hoist engagement rope,
engaging the hoist/interlock.
NOTE: F96 INTERLOCK will be displayed.
2.
Operate the door in the desired direction
by pulling on one side or the other of the
continuous loop chain.
3.
To restore standard electrical operation to the
operator, pull the hoist disengagement rope to
disengage the hoist/interlock.
21
WARNING
To prevent possible SERIOUS
INJURY or DEATH from a falling
door or arm:
•
DISCONNECT electric power
to the operator BEFORE
manually operating your door.
•
DO NOT stand under the
door arm when pulling the
emergency release.
•
If possible, use emergency
disconnect ONLY when door
is CLOSED. Weak or broken
springs or unbalanced door
could result in an open
door falling rapidly and/or
unexpectedly.
•
NEVER use emergency release
handle unless doorway is clear
of persons and obstructions.
Publicidad
