Fein AGSZ18-280BL AS Instrucciones De Uso página 7

For threaded abrasive cones and plugs use
only undamaged wheel mandrels with an
unrelieved shoulder flange that are of cor-
rect size and length. Proper mandrels will
reduce the possibility of breakage.
Do not "jam" a cut-off wheel or apply exces-
sive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the
wheel increases the loading and susceptibil-
ity to twisting or snagging of the wheel in the
cut and the possibility of kickback or wheel
breakage.
Do not position your hand in line with and
behind the rotating wheel. When the wheel,
at the point of operation, is moving away
from your hand, the possible kickback may
propel the spinning wheel and the power
tool directly at you.
When wheel is pinched, snagged or when
interrupting a cut for any reason, switch off
the power tool and hold the power tool
motionless until the wheel comes to a com-
plete stop. Never attempt to remove the cut-
off wheel from the cut while the wheel is in
motion otherwise kickback may occur.
Investigate and take corrective action to
eliminate the cause of wheel pinching or
snagging.
Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power
tool is restarted in the workpiece.
Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag
under their own weight. Supports must be
placed under the workpiece near the line of
cut and near the edge of the workpiece on
both sides of the wheel.
Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can
cause kickback.
Further safety warnings for
working with wire brushes
Safety warnings specific for wire
brushing operations
(AGSZ18-90 LBL AS):
Be aware that wire bristles are thrown by
the brush even during ordinary operation. Do
not overstress the wires by applying exces-
sive load to the brush. The wire bristles can
easily penetrate light clothing and/or skin.
Allow brushes to run at operating speed for
at least one minute before using them. Dur-
ing this time no one is to stand in front or in
line with the brush. Loose bristles or wires
will be discharged during the run-in time.
Direct the discharge of the spinning wire
brush away from you. Small particles and
tiny wire fragments may be discharged at
high velocity during the use of these brushes
and may become imbedded in your skin.
Further safety warnings
Do not use a damaged power tool. Before
each use of the power tool, check the hous-
ing and other components for damage such
as cracks or breakage.
Make sure that the application tools are
mounted in accordance with the manufac-
turers instructions. The mounted application
tools must be able to rotate freely. Incor-
rectly mounted application tools can
become loose during operation and be
thrown from the machine.
Handle grinding accessories carefully and
store them according to the manufacturer's
instructions. Damaged grinding accessories
can develop cracks and burst during opera-
tion.
When using application tools with a
threaded insert, take care that the thread in
the application tool is long enough to hold
the spindle length of the power tool. The
thread in the application tool must match
the thread on the spindle. Incorrectly
mounted application tools can loosen during
operation and cause injuries.
Do not direct the power tool against your-
self, other persons or animals. Danger of
injury from sharp or hot application tools.
en
7