Stihl FC 56 C Manual De Instrucciones página 23

Also use this setting if the engine has
been running but is still cold.
Starting
Place the unit on the ground: Check
N
that the cutting blade is not touching
the ground of any other obstacles.
Make sure you have a firm footing.
N
Hold the unit firmly on the ground
N
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout.
NOTICE
Do not stand or kneel on the drive tube.
FC 56 C
Pull the starter grip slowly with your
N
right hand until you feel it engage
and then continue pulling it slowly
and steadily. Do not pull out the
starter rope to full length – it might
otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until the engine
N
runs.
As soon as the engine runs
Press down the throttle trigger
N
lockout and open the throttle – the
choke lever moves to the run
position F . After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting blade must not
rotate when the engine is idling.
Your machine is now ready for
operation.
Shut off the engine.
Move the momentary stop switch in
N
the direction of 0 – the engine
stops – release the momentary stop
switch – it springs back to the run
position.
Other hints on starting
Engine stalls in cold start position g or
under acceleration
Move the choke lever to < and
N
continue cranking until the engine
runs.
English
21