Specifications; Maintenance And Repairs - Stihl FC 56 C Manual De Instrucciones

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
Single cylinder two-stroke engine
Displacement: 1.66 cu.in
(27.2 cc)
Bore: 1.34 in (34 mm)
Stroke: 1.18 in (30 mm)
Engine power to 1.1 bhp (0.8 kW)
ISO 8893: at 8,500 rpm
FC 56 C
Idle speed: 2,800 rpm
Cut-off speed (rated): 10,000 rpm
Max. output shaft
speed (cutting blade): 8,600 rpm
Ignition System
Electronic magneto ignition
Spark plug (resistor
type): NGK CMR 6 H
Electrode gap: 0.02 in (0.5 mm)
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity: 11.5 fl.oz (0.34 l)
Weight
dry, with deflector and
blade 13.4 lbs (6.1 kg)

Maintenance and Repairs

Users of this unit should carry out only
the maintenance operations described
in this manual. STIHL recommends that
other repair work be performed only by
authorized STIHL servicing dealers
using genuine STIHL replacement parts.
Genuine STIHL parts can be identified
by the STIHL part number, the
{ logo and, in some cases, by
the STIHL parts symbol K. The
symbol may appear alone on small
parts.
For repairs of any component of this
unit's air emissions control system,
please refer to the air emissions
systems warranty in this manual.
English
33