Mounting The Cutting Blade - Stihl FC 56 C Manual De Instrucciones

English
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the star knob so that
N
the handle cannot be rotated on the
shaft.
Adjusting loop handle without star knob
screw
1
Use the combination wrench to
N
loosen the screw (1).
16
Turn the handle to the vertical
N
position.
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.

Mounting the Cutting Blade

Place the edger so that the blade
N
mounting (1) faces upwards
5
6
4
2
3
Insert the locking pin (2) as far as
N
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
Fit Allen wrench (5) onto nut (6).
N
FC 56 C