Tool Settings; Chips Extraction; Ksf-Of Chip Catcher - Festool OF 1010 EQ Manual De Instrucciones

Cutter diameter
1/8"
Material
-
1/2"
3-14 mm
Hard wood 6-4
Soft wood 6-5
Panels 6-5
Plastic 6-4
Aluminium 3-1
Plasterboard 2-1
Cutter
material
5/8" 1-1/8"
- -
1" 1-3/8"
15-25 mm 26-35 mm
5-3 3-1 HW/HSS
6-3 4-1 HSS/HW
6-3 4-2 HW
5-3 2-1 HW
2-1 1 HSS/HW
1 1 HW
4.2
4.1
5.2
The router OF 1010 EQ has solid shaft electronics
with the following functions:
Smooth start-up:
The electronically controlled smooth start-up facil-
ity enables start-up of the machine without jerks
and requires a lower start-up current.
Speed regulation:
Using the electronic speed control (1.1) the motor
speed can be continuously adjusted from 9 500 and
23 000 rpm.
The table aside offers a guide to the correct elec-
tronic setting for various materials. The settings
are naturally infi nitely variable.
Constant speed:
The selected motor speed is electronically main-
tained to a constant level. By this means a uniform
cutting speed is achieved.
Temperature protection:
Extreme overloading during continuous use leads
to the motor overheating. To protect against
overheating (burnout of the motor) an electronic
temperature monitor is installed. Before a critical
motor temperature is reached, the safety electron-
ics switch the motor off. After a cooling down time
of about 3 to 5 minutes, the machine is ready for
operation again and can be fully loaded. The cool-
ing down time can be reduced considerably if the
machine is allowed to idle.
power supply before making any adjustments to
the router or installing or removing any accessory!
A connection for extracting dust and chips (1.6) is
a standard feature on the routers.
At the same time a chip guard (4.1) on the parallel
guide (accessory) prevents fl ying chips. With edge
routing, the best extraction effect is obtained with
the extractor hood AH-OF (accessory).
5.1

KSF-OF chip catcher

Using the KSF-OF chip catcher (sometimes in-
cluded in the scope of delivery), the effi ciency of the
extraction can be increased when routing edges.
Fasten the KSF-OF chip catcher (5.1) to the platen
instead of the cover ring (4.2) from below.
7

Tool settings

Always disconnect the plug from the

Chips extraction