ENGLISH
-
Energy test programme: ECO 40-60. Other preset. Half load for 12.0 kg machine: 6 kg.
-
Quarter load for 12.0 kg machine: 3 kg.
5. CLEANING AND MAINTENANCE
Device exterior and control panel
-
You can wash it with a soft, damp cloth.
-
A little neutral (non-abrasive) detergent can also be used.
-
Use a soft cloth to dry it.
Door gasket
-
Clean it with a damp cloth if necessary. Remove any remaining dirt and inspect that there
are no small objects inside.
-
Check the condition of the gasket regularly.
Detergent dispenser drawer:
-
Press down the washing compartment release lever and pull out the drawer (Fig. 24).
-
Remove the siphon cap in the softener compartment slot.
-
Wash all parts under running water.
-
Replace the siphon cap in the detergent drawer and put the detergent drawer back in
place.
Filter
It is recommended to check and clean the filter regularly, at least two or three times a year,
especially if the filter is used:
-
If the appliance does not drain properly or if it does not perform spin cycles.
-
If the pump is blocked by a strange body (for example, buttons, coins, or pins).
IMPORTANT: make sure that the water has cooled down before draining the device.
-
Stop the appliance and unplug it from the mains.
-
Insert a removal tool, such as a flat-blade screwdriver, into the small opening in the
bottom cover, press the bottom cover firmly to the right and open it.
-
Place a container under the filter door and then drain with the emergency drain hose
(depending on model). Then loosen the filter by turning it anticlockwise, unscrew it
completely and remove the filter.
-
Clean the filter and its compartment.
-
Check that the pump rotor moves freely.
-
Reinsert the filter and screw it in clockwise until it stops.
-
Refit the cover.
Fig.
BOLERO DRESSCODE 120700A
106