Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4.- There are traces of detergent or additives in the detergent drawer after the end of
the wash.
Make sure of the following:
-
The softener compartment lid grille and the washing compartment divider are
correctly installed in the detergent dispenser and all parts are clean (see "Cleaning and
maintenance").
-
There is enough water entering. The mesh filters from the water supply may be blocked.
-
The position of the separator in the washing compartment is adapted to the use of
powder or liquid detergent.
5.- The machine vibrates during the spin cycle.
Make sure of the following:
-
The washing machine is level and stands on its 4 legs.
-
Before using the washing machine, it is necessary to remove the transport screws.
6.- The results of the final spin are not good.
-
The washing machine is equipped with an imbalance detection and correction system.
If heavy single items (e.g., bathrobes) are loaded, this system can automatically reduce
the spin speed or even stop spinning completely if it detects too large an imbalance even
after several spin starts, in order to protect the washing machine.
-
If the laundry is still too wet at the end of the cycle, remove some items and repeat the
spin cycle.
-
Excessive foam formation may prevent spinning. Use the right amount of detergent.
-
Check that the spin speed selector is not in the "O" position.
7.- If your washing machine has a time indicator: the initially displayed programme time
is lengthened/shortened by a period of time.
It is normal for the washing machine to adapt to factors that may influence the washing
programme time, for example:
-
Excessive foaming.
-
Load imbalance due to heavy garments.
-
Longer heating time due to reduced inlet water temperature.
Due to such factors, the remaining programme cycle time is recalculated and, if necessary,
updated. In addition, during the filling phase, the machine determines the load and, if
necessary, adjusts the initial programme time displayed accordingly. During these update
periods, an animation appears on the screen.
8.- Water inlet failure
Attach the inlet hose to the cold water tap and the inlet valve with the blue filter at the rear of
the machine. Fig. 27
Make sure that:
BOLERO DRESSCODE 120700A
108
Publicidad
