cecotec BOLERO DRESSCODE 120700 A Manual De Instrucciones página 86

ENGLISH
Feet adjustment
The appliance must be installed on a solid, level surface (if necessary, use a spirit level,
not included). If the appliance is to be installed on a wooden floor, distribute the weight by
placing it on a 60×60 cm plywood board at least 3 cm thick and fix it to the floor. If the floor is
uneven, adjust the 4 levelling feet as necessary. Do not insert pieces of wood, etc. under the
feet.
1. Loosen the safety nut clockwise (according to the arrow) using the spanner. Fig. 7
2. Raise the machine slightly and adjust the height of the foot by turning it. Fig. 8
Clockwise > up
-
- Counterclockwise > down
3. Tighten the safety nut by turning it counterclockwise. Fig. 9
Make sure that all four feet are stable and flat on the ground.
Bottom plate installation (optional - only on certain models)
For quieter operation, a bottom plate is supplied with the unit (some models only). After
installing the plate on the bottom of the washing machine, the noise level will be reduced
considerably. The washing machine can be used without the bottom plate.
Instructions for the bottom plate installation:
A: Attach the acoustic foam to the side of the bottom plate with the word PUMP.
Tilt the washer 30º-40º and fix the bottom plate so that the word PUMP on the bottom plate
is in the corner of the washer, where the drain pump is located. Fig. 10
B:
1. Before installing the bottom plate, align and glue the acoustic foam along its edge (this
procedure is not necessary for some washing machine models, since they do not have
acoustic foam). Fig. 11
2. Remove the paper from the surface of the double-sided tape on all four sides of the
bottom plate. Fig. 12
3. Tilt the machine at an angle of 40° and let the side with the right-angled notch face the
front of the machine, as shown in Figure 13. Insert the side with the slot at an oblique
angle between the two feet screws at the back of the washing machine. Then install the
bottom plate and make sure that it contacts the bottom of the washing machine. Fig. 13
4. Manually press the double-sided tape on all four sides to fix the bottom plate firmly to
the machine body. Fig. 14
BOLERO DRESSCODE 120700A
86