OHAUS Endeavor 5000 Serie Manual página 10

EN-8
Installation of Test Tube Racks – e-E51LD0420 and e-E51LD0403
1. Turn unit off with power switch.
2. Remove non-skid rubber mat.
3. Align the clip on the rack to the side of the tray.
4. Line up the holes in the test tube rack to the holes in the tray. Using the screws provided, hand tighten into
place using a flathead screwdriver. DO NOT over tighten.
(6) Erlenmeyer Flask Clamps
125 ml – 250 ml
Standard Tray Accessories for e-E51LD0420 and e-E51LD0403 (available separately)
1.5.4
Sticky Mat
30770939
Installation of Sticky Mat
Sticky mats are recommended for flat bottom vessels with a wide base at low speeds. Sticky mat performance may
diminish over time due to spills, dirt and debris.
1. Turn unit off with power switch.
2. Remove non-skid rubber mat.
3. Place sticky mat directly on tray, then place sample on sticky mat. The sticky mat can be repositioned simply
by peeling from the tray.
4. Vessels can be removed by tilting to the side
(4) 500 mL Erlenmeyer Flask
Clamps
Universal Harness e-E51LD
(4 short bands, 2 long bands)
30770940
Endeavor 5000 Series
(2) Tube Racks
Adjustable Platform
30400121