OHAUS Endeavor 5000 Serie Manual página 21

Endeavor 5000 Series
User Programs
2.5.2
The User Programs feature allows the user to create, store, delete, and run a series of shaking programs for repeat
applications in the lab.
Each program can have a maximum of 5 steps and a time must be entered for each step. To keep the shaking off
during a step enter "0" for the speed.
The unit will store up to 8 individual 5-step programs.
To access the Program Feature:
While in Idle Mode, press and hold the Time Adjustment Knob (D) until "MENU" is displayed, after "MENU"

is displayed "RECALL" will appear on the display.
Rotate either the Time Adjustment Knob (D) or Speed Adjustment Knob (E) until "PROG" appears on the

display
Quick press either the Time Adjustment Knob (D) or Speed Adjustment Knob (E) to access the Program

menu and Quick Press to select an option
Run program

o Navigate to the User Program submenu ("PROG")
o Navigate to the Run option
o Navigate existing User Programs
Press and hold the Speed Adjustment Knob (E) until the unit beeps and the Run Status Indicator (C,
o
Figure 1) illuminates
NOTE: While a program is running, the end user cannot adjust the speed or time settings.
o
To stop a program, press and hold the Speed Adjustment Knob (E) until the unit beeps and the
•
Run Status Indicator (C) turns off or turn off the power switch
Create new User Program

Navigate to the User Program submenu ("PROG")
o
o Select the Edit option
o Select new program ("Edit PrGn")
Select new step ("PrG<X> StPn")
o
o Adjust Hours parameter
o Quick press to select Minutes parameter
o Adjust Minutes parameter
Quick press to select RPM parameter
o
o Adjust RPM parameter
o Quick press to confirm step parameters
EN-19