OHAUS Endeavor 5000 Serie Manual página 23

Endeavor 5000 Series
Menu – System Settings
2.5.3
Pause Enable/Disable
Navigate to the System Settings submenu ("SYS")

Navigate to the Pause setting ("PAUS")

Quick press to select value

Rotate knob to select the desired setting (En = Enabled or dIS = Disabled)

Quick press to confirm value

Beeper Enable/Disable
Disabling the Beeper will silence and prevent beeps in the following scenarios:

o Starting and stopping shaking
o When the timer reaches 00:00 in timer countdown mode
Navigate to the System Settings submenu ("SYS")

Navigate to the Pause setting ("BEEP")

Quick press to select value (En = Enabled or dIS = Disabled)

Rotate knob to select the desired setting

Quick press to confirm value

Power Recovery Enable / Disable
Power Recovery is an optional feature that allows the unit to automatically restart the shaking functions

when power is returned to the unit after a disconnect.
Navigate to the System Settings submenu ("SYS")

Navigate to the Power Recovery setting ("PWr")

Quick press to select value (En = Enabled or dIS = Disabled)

Rotate knob to select the desired setting

Quick press to confirm valued

Overload Detection Enable / Disable
Optional load sensing feature which provides protection against improper positioning and excess load

conditions.
The unit will automatically slow to a safe operating speed and display "E4" if a hazardous load is detected.

Error may be cleared by interacting with the unit; shake and timer functions will continue operating as
standard.
Navigate to the System Settings submenu ("SYS")

Navigate to the Power Recovery setting ("LOAD")

EN-21