OHAUS Endeavor 5000 Serie Manual página 11

Endeavor 5000 Series
Installation of Universal Harness
The Universal Harness attaches to tray to secure low profile plates.
1. Turn unit off with power switch.
2. Remove non-skid rubber mat.
3. To use the short bands, install the center post thumbscrew on the tray. Hand tighten into place DO NOT over
tighten,
4. Place sample(s) on tray.
5. Place the short band under the bent down corner of the tray and stretch the short band over the sample(s)
and then place on the center post thumbscrew.
6. To use the long bands, place sample on tray, place the long band under the bent down corner of the tray and
stretch diagonally over the sample and secure to the opposite bent down corner.
Installation of Adjustable Platform
The Adjustable Platform has a non-skid rubber surface with adjustable clamping bars to accommodate various
vessel types. Stainless steel construction.
1. Turn unit off with power switch.
2. Remove non-skid rubber mat.
3. Line up the holes in the Universal Platform to the holes in the tray. Using the screws provided, hand tighten
into place using a flathead screwdriver.DO NOT over tighten.
4. Add glassware. Adjust rollers by loosening each of the thumbscrews. Slide the padded rollers to the desired
position and retighten the thumbscrews.
Microplate Shaker Tray Setup
1.5.5
The Microplate Shaker is designed to hold two (2) or four (4) microplates, or two (2) Micro-Tube Racks.
1. Turn unit off with power switch
2. Place two (2) microplates or deep well blocks diagonally on the tray, or place four (4) microplates or
deep well blocks on the tray. The plates/blocks do not have to be filled.
3. Place the corner of the plate/block under the spring located at each corner of the tray.
4. Slide plate/block into place. You are ready to use.
NOTE: The tray on the Microplate Shaker is not designed to hold flask clamps
1.
2.
3.
EN-9