OHAUS Endeavor 5000 Serie Manual página 9

Endeavor 5000 Series
Device Setup
1.5.2
Light duty/microplate shaker
A
B
C
A. LCD
B. Timer Adjustment Knob
C. Timer Status Indicator
D. Power Switch
E. Run/Speed Status Indicator
F. Speed Adjustment Knob
Standard Tray Configurations
1.5.3
The Light Duty Shaker is supplied with a tray designed to hold a variety of accessories (available separately).
1. Flat containers can be shaken by placing them on the non-skid rubber mat provided with the unit.
2. The tray also has mounting holes ready for use with flask clamps or test tube racks. See below examples of
tray configurations.
Installation of Flask Clamps - e-E51LD0420 and e-E51LD0403
1. Turn unit off with power switch.
2. Remove non-skid rubber mat.
3. Line up the hole(s) in the flask clamp to the hole(s) in the tray. Using the screw(s) provided, hand tighten into
place using a flathead screwdriver. DO NOT over tighten.
4. Insert flask/media bottle into clamp and wrap the spring around the neck of the clamp to hold secure. For PVC
flask clamps, simply place vessel in clamp.
F
E
D
G
G. RS232 Port
H. DC Power Connector
EN-7
H