Before Using - Hitachi Koki C 10FSHC Instrucciones De Seguridad Y Manual De Instrucciones

Tronzadora radial abatible
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
5.
Power cord storage
Bracket (A)
Bracket (B)
For convenience and to prevent damage to the power cord when the miter saw is not in use
or is in transportation, there are two brackets at the rear side of the slide carriage for winding
the cord. (Fig. 8-a)
NOTE:
To rapidly release the power cord, turn the upper bracket (A) 180°. It will
release the cord. (Fig. 8-b)

BEFORE USING

1.
Make sure the power source is appropriate for the tool.
WARNING:
2.
Make sure the trigger switch is turned OFF.
WARNING:
3.
Check the saw blade for visible defects.
Confi rm that the saw blade is free of cracks or other visible damage.
4.
Confi rm that the saw blade is attached securely to the power tool.
Using the supplied 13 mm wrench, tighten the 8 mm bolt on the saw blade spindle to secure
the saw blade.
For details, see Fig. 44-a, Fig. 44-b, Fig. 44-c and Fig. 44-d in the section on "SAW BLADE
MOUNTING AND DISMOUNTING".
16
Fig. 8-a
Never connect the power tool unless the available AC power
source is of the same voltage as that specifi ed on the nameplate
of the tool.
Never connect this power tool to a DC power source.
If the power cord is connected to the power source with the
trigger switch turned ON the power tool will start suddenly and
can cause a serious accident.
Bracket (A)
Bracket (B)
Fig. 8-b

Publicidad

Tabla de contenido
loading

Tabla de contenido