Hitachi Koki C 10FSHC Instrucciones De Seguridad Y Manual De Instrucciones página 34

English
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 32 (see Fig. 33; tilt the motor
head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (Ⓐ in Fig. 31) contacts the fence
as indicated in Fig. 35.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 32 (see Fig. 34; tilt the head to
the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (Ⓑ in Fig. 31) contacts the fence
as in Fig. 36.
1
Miter angle
scale
Turntable
Fence
Ⓐ
34
Head
Bevel angle scale
4
Fence (A)
Base
Fig. 33
Ⓑ
Table on base
Fig. 35
35.3°
31.6°
30°
33.9°
35.3°
31.6°
30°
33.9°
2
Fence (B)
Base
Fence
Ⓑ
Head
Bevel angle scale
3
Miter angle scale
Turntable
Fig. 34
Ⓐ
Table on base
Fig. 36